Liz Corke Knit Design

Show cart
September 30, 2013

This is my absolute favourite cast on for anything that needs to stretch. I’m releasing a pattern for fingerless mitts tomorrow and I wanted to share this cast on with you all. It’s a variation on a long tail cast on, and this is how it works.

Alternating Cast On 1

1. Start by holding the yarn around your thumb and index finger. The ball
end should be round the thumb and the yarn tail round the index finger.

Alternating Cast On 2

2. Take the needle from the back of the hand under the yarn between your thumb and index finger and twist it through 180°.

Alternating Cast On 3

3. Take the needle tip under the yarn on your thumb.

Alternating Cast On 4

4. Next take the needle over, then under the yarn on your index finger.

Alternating Cast On 5

5. Bring the needle back through the thumb loop.

Alternating Cast On 6

6. Drop the yarn from your thumb and tighten the stitch.

Alternating Cast On 7

7. Pick up the yarn with your thumb, but this time it should go round the opposite way.

Alternating Cast On 8

8. Take the needle tip under the yarn on your thumb.

Alternating Cast On 9

9. Next take the needle over, then under the yarn on your index finger.

Alternating Cast On 10

10. Bring the needle back through the thumb loop, then drop the yarn from your thumb and tighten the stitch.

Alternating Cast On 11

Pick up the yarn as in step 2 and work from step 3 to 10 repeating until you have the required number of stitches. The stitches should be arranged neatly in pairs.

Once you’ve knit an inch or two of ribbing, test out how stretchy it is!